UV-DTF Instructions

STEP 1:

Measure your transfer against the product you are applying to, to ensure it fits. Make sure you cut any excess, being careful to avoid your design.

 

STEP 2:

Your transfer needs to be warmed up! This will help when removing the laminated cover. You can warm up by gently rubbing the design in your hands. It is also helpful to work in a warm room. The colder the room/item, the harder it is!

 

STEP 3:

Grab yourself a squeegee and gently rub over your design before peeling from the carrier sheet. You could also use a bank card,

 

If you have any difficulty removing your design, please make sure you repeat this step.

 

STEP 4:

Place your transfer against the product of choice - remember as soon as it’s stuck in place, you cannot move it. Be gentle and cautious of your positioning.

 

STEP 5:

Begin to press your transfer down, working your way from the centre outwards. Make sure you push out any air bubbles you can see. You may be able to pop any remaining bubbles once finished by using a fine pin needle.

 

STEP 6:

Now the fun really begins! It’s time to slowly remove the carrier sheet - aka the clear film. Start off slowly, peeling diagonally and make sure you don’t remove any of your design. If some of the design lifts, push it back down and rub. This should help the adhesion

 

We recommend giving a care card to all customers to remind them of basic care instructions.